EPS cutting tools
Which tools are used to cut EPS and XPS?
The EPS cutting tools in the ESTonetex catalog cut expanded polystyrene (EPS), extruded polystyrene (XPS) and foams of any density, using a hot wire or blades. They are used for theming figures and sculptures, for hollowing out and for ETICS (SATE) boards. The category groups 12 products:
- EST EPS Cutter Kit: hot-cutting kit with power supply, handles and wire. EST Arch Cutter: battery-powered hot-wire cutting bow. EST Arch Cutter 35 cm: lightweight hot-wire bow that cuts up to 32 cm wide and 20 cm deep.
- EST Power Supply: 48 V, 480 W power supply with temperature regulator, to connect cutting bows, cutting tables and other hot-wire tools.
- EST EPS Knife: thermal knife with temperature regulator that reaches up to 600 °C.
- EST Rigid Blade 15 cm and EST Rigid Blade 20 cm: rigid blades to cut and hollow out EPS, XPS and foams.
- Nichrome wires for hot cutting: 0.15 mm, 0.25 mm, 0.45 mm, 0.65 mm and 1.5 mm.
Frequently asked questions
Which tool cuts expanded and extruded polystyrene?
According to the catalog, the EST EPS Knife cuts EPS and XPS, the rigid 15 and 20 cm blades cut and hollow out EPS, XPS, polystyrenes and foams of any density, and the bows and nichrome wires cut with heat.
What is needed to use a hot-wire bow?
A power supply. The EST Arch Cutter 35 cm does not include one (the catalog recommends 24 V and 200 W) and the 48 V, 480 W EST Power Supply is used to connect cutting bows, cutting tables and hot-wire tools.
Which nichrome wire should I choose?
The catalog states that the 0.15, 0.25, 0.45 and 0.65 mm wires are suitable for the EST EPS Cutter Kit and the 1.5 mm wire for the EST EPS Knife; all are for hot cutting.
What is used to cover the EPS once it is cut?
For theming, the catalog lists ESTonetex Forte (thin layer on EPS/XPS, primer and finish) and ESTonetex Fibrax (super-fibered primer for EPS/XPS). See the Mortars category.